mini z/x mod body

[modmaniac87]

Does anyone know an easy way to mount a mini z body on an x mod chassis or vise versa :?:

[DaShogun]

basicly its the same with the clodbuster / juggernaut / custom ABC platsic bodies. You have to do a lot of work to get it the way you like it. Basicly center it. Then drill holes at the right area. Make sure you know where the body posts exactly are. Use a sharpie or somesort to do that.

[racinlosi]

Or if you want to spend a little bit extra and use them forever, you can get the "no brainer body post marks" that componies make to get it right no matter what.

[DaShogun]

thats really expensive and don't think I would like spending that money. It also leaves a dent in the body. To add a little shaz you can buy hard bodies or aluminum bodies from model car kits. You would have more choices are model car kits are about 1/18 or smaller scale.

[racinlosi]

actually, it wont do that, and it's not that much more for the body marker thing, it doesn't cost that much either. Ity just dents the body so you know where to drill it at without mistakes.

[DaShogun]

If you save that money you can buy something else good. I just put a little dab of washable marker on the body post. Put the body on it how I like it and press it down. The washable marker should leave a small dot and you can just wipe that off with your finger when you're done drilling the hole.